Option 208 DC power supply 180-235V, 3 phase AC,50/60Hz INPUT (use with power cord opt 861)
|
|
HP / Agilent 6681A 5000W DC Power Supply
This Single-Output, 5000W, GPIB Agilent
6681A dc power suppy has the exceptional, proven
reliability that test system engineers look for. It also has the features
needed for easy test system integration.
Programming of the dc output and the
extensive protection features can be done either from the front panel or
using industry standard SCPI commands, via the GPIB. Using the serial
link, up to 16 power supplies can be connected through one GPIB address.
Test system integration can be further simplified by using the VXI Plug&Play drivers. The output voltage and currentcan also be controlled with
analog signals. This is helpful for certain types of noisy environments,
and also immediate reactions to process changes.
The HP / Agilent 6681A 5000W DC Power Supply has extremely low ripple
and noise for a 5000 watt dc power supply. This helps the built-in
measurement system make extremely accurate current and voltage
measurements. Selectable compensation is provided for problem-free
powering of inductive loads.
| HP / Agilent 6681A Specifications |
| Number
of outputs |
1 |
| GPIB |
Yes |
| Output
ratings |
| Voltage |
0
to 8 V |
Current
(40°C then derate linearly 1%/°C
from 40°C to 55°C) |
0
to 580 A |
| Programming
accuracy at 25°C ±5°C |
| Voltage
(0.04% +) |
8
mV |
| Current
(0.1% +) |
300
mA |
| Ripple
and noise constant voltage mode from 20 Hz to 20 MHz |
| rms |
1.5
mV |
| Peak
to peak |
10
mV |
| Readback
accuracy at 25°C ±5°C (percent of reading plus fixed) |
| Voltage
(0.05% +) |
12
mV |
| Current
(0.1% +) |
400
mA |
| Load
and line regulation |
| Voltage
(0.002% +) |
0.3
mV |
| Current
(0.005% +) |
40
mA |
| Transient
response time |
Less than 900 µs for the output
voltage to recover within 150 mV following a change in load from
100% to 50%, or 50% to 100% of the output current rating of the
supply |
Ripple and noise constant current
mode from 20 Hz to 20 MHz |
| rms |
190
mA |
| Average
programming resolution |
| Voltage |
2.15
mV |
| Current |
155
mA |
| OVP |
45
mV |
| Output
voltage programming response time |
12
ms |
| (excludes
command-processing time) Full-load progrmming rise or fall time (10
to 90% or 90 to 10%, resistive load) |
Output common-mode noise current (to
signal-ground binding post) |
| rms |
1.5
mA |
| peak-to-peak |
10
mA |
|
