 |
|
Dual-Channel, Dynamic Signal Analyzer 64 µHz to 100
kHz
- Network, spectrum, waveform, transient analysis
- Linear, logarithmic, swept sine modes
- 80 dB dynamic range with full alias protection
- High accuracy (±0.15 dB)
Frequency Response Measurements
- With linear resolution FFT logarithmic resolution and swept sine analysis
- Built-in signal source provides a variety of random noise and sine wave signals
Spectrum Analysis
- On-line analysis of distortion, drift, modulation, and phase noise
Waveform and Transient Analysis
- Analysis of waveforms and transients in the time and frequency domains
- Array of triggering capabilities enhances both waveform recording modes.
Pre- and post-trigger delays can be specified
Hardcopy and Mass Storage
- HP-IB
- With direct control of plotters and disk drives
Specifications
Frequency
- Measurement Range: 64 µHz to 100 kHz. Both channels, single- or
dual-channel operation
- Resolution: span/800
| Spans |
Baseband |
Zoom |
| # of spans |
66 |
64 |
| min span |
10.24 mHz |
20.48 mHz |
| max span |
100 kHz |
100 kHz |
| time record (sec) |
800/span |
800/span |
- Window functions: flat top, Hann, uniform, force, exponential, user-defined
- Typical real-time bandwidths: Single-channel, fast averaging 10 kHz
Amplitude
- Input Ranges: +27 dBV to -40 dBV; -41 dBV to -51 dBV
Input
- Input Impedance: 1Mohm ±5% shunted by < 100 pF
- Input Coupling: inputs can be ac or dc coupled - ac rolloff is < 3 dB at 1 Hz
Trigger
- Trigger Modes: free run, input channel 1, input channel 2, source and external
trigger
- Trigger Delay: pre- and post-trigger delay resolution is 1 sample (1/2048 of a
time record)
- Pre-trigger: a measurement can be based on data that starts from 1 to 4096
samples (1/2048 to 2 time records) before trigger conditions are met
- Post-trigger: a measurement is initiated from 1 to 65,536 samples (1/2048 to 32
time records) after the trigger conditions are met
Source
- Random noise, burst random, sine chirp, burst chirp, fixed sine, and swept sine
are available
- Output Impedance: 50 ohm (nominal)
- Output Level: between +10 and -10 V peak (ac + dc) into a ≥ 10 kohm
- ac level: ±5 V peak
- dc offset: ±10 V peak in 100 mV steps
|