• Safe, Fast, Efficient
• Fully programmable test parameters
• Digital display
• Performs an AC dielectric strength (Hipot) test concurrent with a ground continuity test
• Applies a test potential of up to 5000 VAC at 50 milliamps (user programmable )
• Performs tests in full compliance with UL, VDE, BSI, IEC, CSA, and other test standards

IEEE-488 BUS-compatible - enables data logging during each test, and remote programming of:

• Test Voltage
• Test Time
• Voltage Ramp Rate
• Real Current Trip Point
• Total Current Trip Point
• Under Current Trip Point

Detects and indicates the following events:

• Test Ready (Security Chassis Ground Sensed)
• Test in Progress
• Test Passed
• Test Failed:
  * Arcing
  * Excessive Total Leakage Current
  * Excessive Resistive Leakage Current
  * Under Current
  * Lack of adequate Chassis Ground

Superior Safety Features

• Visual and Audible alert indicating Hipot test in progress
• Low Current Security Chassis Ground Circuit (ensures Device Under Test has ground connection of 0.5 ohm between chassis and power cord ground pin)
• Fast HV shutdown within 2 milliseconds of HV test automatically on test failure or on command

Specifications

• Output Test Voltage*: 100 VAC - 5K VAC
• Output Voltage Ramp Time*:  50 V/sec to 5k V/sec
• Total Current Trip Point*:  50 mA (maximum)
• Real Current Trip Point*:  5 mA (maximum)
• Under Current Trip Point*:  5 mA (maximum)
• Test Time*:  1 sec - 100 sec
• Shutdown Time: 2 milliseconds
• Arc Detection: Arc duration 10µS or greater
• Ground Continuity: Low current ( 1.5 Amp @ 1.5V )
• Input Power Required: 115 / 230 VAC ± 10%, 47 - 63 Hz, 250 watts maximum

* User Programmable