 |
|
TTC T-Berd 950
Communications Analyzer
Product Features:
-
Multiple
service testing capabilities combined in a single test instrument
-
Analog
and digital testing support
-
Growth-oriented
protocol service board and interface module expansion slot for future
test access capability
-
TNT
Task Based Testing user interface makes routine test set-up simple and
intuitive
-
Large
graphical LCD allows for two user display screens and a two-line
results display
-
Use
AC or battery power with dual hot-swappable, field replaceable
batteries
Application
Highlights:
-
Qualify
local loop copper wire pairs for both analog and digital services
-
Perform
full-duplex monitoring of active T1 and DDS lines
-
Verify
and troubleshoot ISDN BRI and PRI services
-
Test
the ability to handle incoming calls with PBX/Switch emulation
-
Install
and maintain frame relay service from T1, DDS, and Datacom interface
- Perform
IP service verification and trouble isolation from a 10BaseT interface
Functions:
-
Perform
standard T1 BER testing and signal analysis measurements
-
Gain
T1/FT1 access for BER testing with standard and advanced stress
patterns, as well as built-in T1 smart repeater and HDSL loopcodes
-
Test
end-to-end WAN service through DTE/DCE equipment emulation and
in-service monitoring
-
Perform
TIMS measurements for qualification of voice and data circuits; place,
receive calls, and perform signaling event/digit analysis on analog
loop start, ground start, and DID voice circuits
-
Verify
circuit-switched ISDN BRI voice, data, and D packet services by
performing NT1 and T BERT, or NT1/TE emulation
|
