Features

• Full Frame Line Select
• Simultaneous Channel A and B Display
• Dual Filter Display
• One-button Front Panel Recall
• RGB/YRGB Display Capability
• Displays D-2 Servo Waveforms
• Parallax-free Internal Graticules
• Remote Control Capability

CHARACTERISTICS

Signal Input (Video and External Reference)

• Return Loss: >40 dB, 50 kHz to 6 MHz, power on or off
• Maximum Input: ±5 V DC + peak AC

Vertical Deflection

• Deflection Factor: Within 1% of 1 V
• Gain Range: Input signals between 0.8 V and 2 V can be adjusted to a 1 V display; (160 mV and 400 mV for X5 gain)

Frequency Response

• Flat: 50 kHz to 6 MHz within 2% (X1), within 5% (X5)
• Low Pass: 40 dB attenuation at F_sc; Low pass response within 1% of flat response (1735: 30 dB)
• Chroma: Nominal bandwidth 1 MHz; 2X F_sc attenuation > 20 dB; Chroma response within 1% of flat response

Transient Response

• Preshoot: <1%
• Overshoot: <2%
• Ringing: <2%
• Tilt: <1%
• Pulse-to-bar Ratio: 0.99:1 to 1.01:1
• Differential Gain: <1%

DC Restoration

• Clamp Time: Back porch
• Frequency Response: Attenuation of 60 Hz on input signal:
  Slow mode: <20%; Fast mode: >90%
• Blanking Level Shift: A 10% to 90% APL change will cause <1% of blanking level shift

PIX Monitor Output

• Frequency Response: 50 kHz to 6 MHz within 3%
• Differential Gain: <1%
• Differential Phase: <1%
• DC Level on Output: <0.5 V into 75 Ohm load
• Intensification (Brightup): 180 mV DC offset on select lines
• Output Impedance: 75 Ohm nominal
• Input to Output (PIX MON) Gain Ratio Luminance: 1:1 ±5% at 15 kHz

Calibrator

• Frequency: 100 kHz ± 0.1 kHz
• Timing Accuracy: 10 µs, ±0.01 µs
• Amplitude: 1 V, ±1%

Horizontal Deflection System

• Sweep: Sweep will occur with or without input signal
• 1-Line Repetition Rate: Equal to applied line rate, magnification equals 0.2 ms/div
• 2-Line Repetition Rate: Equal to half applied line rate, magnification equals 1 ms/div
• 2-Field Repetition Rate: Equal to applied frame rate, magnification equals approximately X25
• Timing Accuracy:
  1 ms/div: Within 2%
  0.2 ms/div: Within 3%
• Linearity: within 2%
• Differential Linearity: Within 2%

Synchronization

• Internal: Composite video or black burst with sync ±6 dB of nominal
• External: Sync amplitude of 143 mV to 4 V
• Remote Sync: 2.0 to 5.0 V square wave or 4.0 V comp sync (sync polarity can be internally inverted)
• RGB/YRGB: Repetition rate: Field rate and line rate with magnification of X25 and X10, respectively.  Sweep Length:
  3-Step (RGB): 3.4 to 4.1 divs
  4-Step (YRGB): 2.5 to 3.1 divs