 |
|
Fluke 97 50MHz ScopeMeter
Specifications
| Bandwidth |
50 MHz Dual Channel |
| Sample Rate |
25 Megasamples/second |
| Autoset |
Automatically sets Voltage, Time & Trigger |
| Multimeter Display |
3 2/3 Digits (> 3000 Counts) |
| True RMS Volts |
AC or AC+DC up to 600V (1700V Pk-Pk) |
| Resistance |
30 ohm to 30 Mohm |
| Diode Test |
Up to 2.8V |
| Time/Division |
10 ns/div to 60 sec/div |
| Volts/Division |
1 mV/div to 100 V/div |
| Digital Delay or Pre-Trigger |
By Number of Cycles, Events, Time or Zoom Mode |
| Special Multimeter Modes |
Min Max Average Record with Time Stamp, Relative (zero), dBm, dBV, dBW, Audio Watts, %Scale, Frequency, %Duty Cycle, Smoothing™, Change Alert™ |
| Oscilloscope Cursors |
15 Measurements, Display 5 Simultaneously |
| Glitch Capture |
≥40 ns |
| Waveform Processing |
Average, Min Max, Record, Variable Persistence |
| Waveform Memory |
Store & Recall 8 Waveforms |
| Set-up Memory |
Store & Recall 10 Front Panel Set-Ups |
| Waveform Mathematics |
Add, Subtract, Multiply, Invert, Filter or Integrate Waveforms |
| Signal Generator Output |
Sine wave or Square wave |
| Component Tester Output |
Voltage or current ramp |
| Size |
2.4" H x 5.1" W x 10.2" L |
| Weight |
3.3 lbs |
Power Supply
| Internal Battery Pack |
NiCad, 4.8V |
| Operating Time |
4 hours / typical |
| Line Voltage Adapter/Battery Charger |
standard |
|
