 |
|
4 Channel, 500MHz Digital Oscilloscope
The Tektronix TDS3054B 4 Channel, 500MHz Digital Oscilloscope packs the power of digital phosphor
oscilloscope technology, WaveAlert automatic anomaly detection,
OpenChoice documentation and analysis solutions with e*Scope®
web-based remote control, and five application-specific modules into a
lightweight, battery-capable design.
DPO technology delivers superior insight into complex
signals with the ability to display, store and analyze three dimensions of
signal information in real-time: amplitude, time, and distribution of
amplitude over time. Fast waveform capture rates make it easier to capture
and display infrequent waveforms or waveform variations, while the
intensity graded display helps you locate and characterize wave-form
anomalies that can be elusive on traditional digital storage
oscilloscopes.
WaveAlert waveform anomaly detection speeds your
troubleshooting tasks by helping you find those elusive problems faster.
WaveAlert detection monitors the incoming signals on all channels and will
detect and highlight any waveform that deviates from the normal waveform
being acquired. Because the Tektronix TDS3054B 4Channel, 500MHz Digital Oscilloscope can stop acquisition,
sound a beep, make a hard copy or save the waveform when it detects an
anomaly, you can run tests over long time periods even unattended
to find those challenging, very infrequent failures.
Tektronix TDS3054B Specifications:
Bandwidth |
500 MHz |
Channels |
4 |
Sample rate on each channel |
5 GS/s |
Maximum record length |
10 K points on all models |
Vertical resolution |
9 Bits on all models |
Vertical sensitivity (/div) |
1 mV 10 V on all models |
Vertical accuracy |
±2% on all models*2 |
Max input voltage (1 MΩ) |
150 VRMS CAT I on all models (300 V CAT II
with standard 10X probe) |
Position range |
± 5 div on all models |
BW limit |
20, 150 MHz |
Input coupling |
AC, DC, GND on all models |
Input impedance selections |
1 MΩ in parallel with 13 pF or 50 Ω |
Time base Range |
1 ns 10 s/div |
Time base Accuracy |
20 ppm |
Display monitor |
Color LCD |
*2 Requires TDS3AAM module. |
