Home > Standards > MIL Standards > MIL-STD-461G CS118: Personnel Borne Electrostatic Discharge (ESD)

MIL-STD-461G CS118: Personnel Borne Electrostatic Discharge (ESD)

Rent Teseq NSG 435 ESD Simulator System

Teseq NSG 435
ESD Simulator System


 

Rent Noiseken ESS-S3011 30kV Electrostatic Discharge Simulator

Noiseken ESS-S3011
30kV Electrostatic Discharge Simulator


 

Rent Haefely Onyx Electrostatic Discharge 16 kV or 30 kV ESD Simulator

Haefely ONYX ESD Simulator

The New MIL-STD-461G, CS118, has added the Electrostatic Discharge testing section of conducted susceptibility, referred to as CS118.  The ESD levels, test setup and test equipment are similar to IEC 61000-4-2 and RTCA/DO-160.  In order to see the full version released on 12/11/15, click here for MIL-STD-461G.

 

CS118 Applicability

 

This requirement is applicable to electrical, electronic, and electromechanical subsystems and equipment that have a man-machine interface. It is not applicable to equipment that interfaces with or controls ordnance items.

 

CS118 Limits

 

The EUT shall not exhibit any malfunction, degradation of performance, or deviation from specified indications, beyond the tolerances indicated in the individual equipment or subsystem specification, when subjected to the values shown Table CS118-1. Contact up to 8kV is the required method. Air discharges shall be required only if specified by the procuring activity.
 

Purpose

 

This test procedure is used to verify the ability of the EUT to withstand personnel borne electrostatic discharge (ESD) in a powered up configuration:

 

  • ESD Simulator Gun
  • • LISN or other Isolation Transformer
  • • GP: Ground Reference Plane (Aluminum or Sheet Metal)
  • • HCP: Horizontal Plane (Aluminum or Sheet Metal)
  • • VCP: Vertical Coupling Plane (Aluminum or Sheet Metal)
  • • 470 kOhm Resistor Cables to mount from HCP/VCP to GP
  • • Insulation Material (Polyvinyl Chloride preferred material)

 

Get a quick overview with this Demo Video of a Teseq NSG438 ESD Gun.