Anritsu S332D Site Master Cable and Antenna Analyzer

Rent Anritsu S332D Site Master Cable and Antenna Analyzer
Enlarge Image
Rent Anritsu S332D Site Master Cable and Antenna Analyzer Rent Anritsu S332D Site Master Cable and Antenna Analyzer Rent Anritsu S332D Site Master Cable and Antenna Analyzer
Request Quote Print Page
Manual Datasheet
Wireless market competition requires operators to reduce per site maintenance expense. The Anritsu S332D Site master's Frequency Domain Reflectometry (FDR) techniques break away from the traditional fix-after-failure maintenance process by finding small, hard to identify problems before major failures occur.



Sixty to eighty percent of a typical cell site's problems are caused by problematic cables, connectors and antennas. When cables or antennas are contaminated with moisture, damaged, or mispositioned during storms, the Anritsu Sitemaster identifies the problem quickly. Antenna degradation reduces the cell coverage pattern and can cause dropped calls. Anritsu S332D Site Master can pinpoint the antenna problem from ground level in a few seconds making climbing the antenna tower unnecessary.


A poorly installed weather seal will corrode connectors and, if undetected, will eventually damage an expensive coaxial cable. The Anritsu S332D Sitemaster has the sensitivity to identify the connector problem before the cable is damaged. Distance-To-Fault provides the clearest indication of troubled areas.


Features:

Function Benefits
Cable and Antenna Analyzer Characterize antenna system and pinpoint location of faults
Standard TFT Color Display Display is viewable in direct sunlight
Power Monitor Performs accurate broadband power measurements using an external detector
Power Meter Performs accurate power measurements up to 3 GHz without the need of an external detector
GPS Receiver Provides location (latitude, longitude, altitude) and UTC time information
Spectrum Analyzer Easily locate, identify and record various signals with high accuracy
AM/FM Demodulator

Built-in demodulator for AM, narrow band FM, wide band FM, and SSB allows technician to listen to and identify interfering signals

Built-in Bias Tee No need to use external power to bias an amplifier
Transmission Measurement

Identify and locate interfering signals that cause dropped calls and coverage problems. Intermittent problems can be identified using spectrograms

Interference Analyzer

Identify and locate interfering signals that cause dropped calls and coverage problems. Intermittent problems can be identified using spectrograms

Channel Scanner Measure frequency, bandwidth and power of multiple transmitted signals
CW Signal Generator CW source to test low noise amplifiers
 

Specifications:

Frequency Range 25MHz - 4.0GHz
Frequency Accuracy ≤±75ppm @ +25°C
Frequency Resolution 100kHz
Output Power <0dBm (-10dBm nominal)
Immunity to Interfering Signals On-channel: +17dBm
On-frequency: -5dBm
Measurement Speed ≤3.5msec / data point (CW ON)
Number of Data Points 130, 259, 517
Return Loss Range: 0.00 - 60.00dB
Resolution: 0.01dB
VSWR Range: 1.00 - 65.00
Resolution: 0.01
Cable Loss Range: 0.00 to 30.00dB
Resolution: 0.01dB
Measurement Accuracy >42dB corrected directivity after calibration
Distance-to-Fault
Vertical Range Return Loss: 0.00 - 60.00dB
VSWR: 1.00 - 65.00
Horizontal Range data pts -1)x Resolution to a maximum of 1197m (3929 ft), # of data pts = 130, 259 or 517
Horizontal Resolution (Rectangular Windowing) Resolution (meter) = (1.5 x 108) x (Vp)/DF Where Vp is the cable's relative propagation velocity and where DF is the stop frequency minus the start frequency (in Hz)