Tektronix 1750 NTSC Waveform/Vector Monitor

Tektronix 1750 NTSC Waveform/Vector Monitor
Enlarge Image
Tektronix 1750 NTSC Waveform/Vector Monitor Tektronix 1750 NTSC Waveform/Vector Monitor Tektronix 1750 NTSC Waveform/Vector Monitor
Request Quote Print Page

The 1750 Series Waveform/Vector Monitors are comprehensive signal monitors that also provide extended measurement capability. These signal monitors can be retrofit into existing systems that use 1/2 rack width, 5 1/4 inch waveform or vector monitors.
 

The 1750 Series combines conventional monitoring capabilities with the ability to perform SCH phasing tasks that until now have required additional instrumentation. SCH phase and color frame matching can be measured directly by using the SCH mode. This capability makes the 1750 Series ideally suited to production and editing applications where the maintenance of SCH phase and color frame relationship is critical.
 

Features:

  • Dual Filter/Simultaneous Display
  • Two Instruments in One
  • SCH Phase and Color Framing
  • R-Y (V-Axis) Mode
  • RGB/YRGB Mode
  • Remote Control Capability
  • Line and field selection for VITS / ITS monitoring
  • Comprehensive signal monitoring

 

Specifications:

Waveform Mode (Vertical Deflection System)
Deflection Factor 1V input for 140 IRE display
Gain Ranges Input signals between 0.7 V and 2 V can be adjusted to 140 IRE
Frequency Response Flat: ±2% from 50 kHz to 6 MHz
IRE: Conforms to IEEE Standard 205
CHROMA: Response at 3.58 MHz does not vary between FLAT and CHROMA by more than 1%
Pix Mon Output Frequency Response: 50 kHz to 6 MHz
Output Impedance: 75Ω
Calibrator Signal Frequency: 100 kHz
Amplitude: 1 V
Waveform mode (Horizontal Deflection System)
Sweep Sweep will occur in all Horizontal mode settings with or without synchronization
1FLD sweep repetition rate
2FLD sweep repetition rate
1H sweep repetition rate
2H sweep repetition rate
Vector Mode
Chrominance Bandwidth Upper: -3 dB Point Fsc +500 kHz, ±100 kHz
Lower: -3 dB Point Fsc -500 kHz, ±100 kHz