Tektronix TDS3052B Digital Phosphor Oscilloscope 500 MHz, 5Gs/s

Rent Tektronix TDS3052B Digital Phosphor Oscilloscope 500 MHz, 5Gs/s
Enlarge Image
Tektronix Test Equipment TDS3052B
Request Quote Print Page
Manual Datasheet
The Tektronix TDS3052B has been replaced by the Tektronix TDS3052C.

View the TDS3052C

 





The Tektronix TDS3052B Digital Phosphor Oscilloscope 500 MHz, 5Gs/s packs the power of digital phosphor oscilloscope technology, WaveAlert automatic anomaly detection, OpenChoice documentation and analysis solutions with e*Scope® web-based remote control, and five application-specific modules into a lightweight, battery-capable design.
 

DPO technology delivers superior insight into complex signals with the ability to display, store and analyze three dimensions of signal information in real-time: amplitude, time, and distribution of amplitude over time. Fast waveform capture rates make it easier to capture and display infrequent waveforms or waveform variations, while the intensity graded display helps you locate and characterize wave-form anomalies that can be elusive on traditional digital storage oscilloscopes.
 

WaveAlert waveform anomaly detection speeds your troubleshooting tasks by helping you find those elusive problems faster. WaveAlert detection monitors the incoming signals on all channels and will detect and highlight any waveform that deviates from the normal waveform being acquired. Because the TDS3052B oscilloscope can stop acquisition, sound a beep, make a hard copy or save the waveform when it detects an anomaly, you can run tests over long time periods even unattended to find those challenging, very infrequent failures.
 

 
Tektronix Test Equipment TDS3052B Specs

Bandwidth

500 MHz

Channels

2

Sample rate on each channel

5 GS/s

Maximum record length

10 K points on all models

Vertical resolution

9 Bits on all models

Vertical sensitivity (/div)

1 mV 10 V on all models

Vertical accuracy

±2% on all models*2

Max input voltage (1 MΩ)

150 VRMS CAT I on all models (300 V CAT II with standard 10X probe)

Position range

± 5 div on all models

BW limit

20, 150 MHz

Input coupling

AC, DC, GND on all models

Input impedance selections

1 MΩ in parallel with 13 pF or 50 Ω

Time base Range

1 ns 10 s/div

Time base Accuracy

20 ppm

Display monitor

Color LCD

*2 Requires TDS3AAM module.