Megger S1-1568 Insulation Resistance Tester
- Resistance measurement: 15 TΩ - 5 kV, 35 TΩ - 10 kV, 35 TΩ - 15 kV
- High current – 6 mA short circuit current
- High noise immunity – 8 mA of noise rejection
Fluke 1550C Insulation Resistance Tester 5 kV
- Test voltages up to 5 kV provides solutions for all applications
- CAT III 1000 V, CAT IV 600 V safety rating
- Voltage breakdown detection alerts the user that voltage is present and gives the voltage reading up to 600 V ac or dc for increased user safety
Megger S1-1068 Insulation Resistance Tester
- Resistance measurement: 15 TΩ - 5 kV, 35 TΩ - 10 kV, 35 TΩ - 15 kV
- High current – 6 mA short circuit current
- High noise immunity – 8 mA of noise rejection
Megger MIT1025 Diagnostic Insulation Resistance Tester
- Measures up to 20 TΩ
- PI, DAR, DD, SV and ramp test
- Improved productivity – operate from line power/mains if battery dead
Fluke 1625-2 GEO Earth Ground Tester
- 3- and 4-pole earth ground measurement
- 4-Pole soil resistivity testing
- 2-pole resistance measurement AC
AEMC 6555 Digital Megohmmeter
- Wide measurement range from 10kΩ to 30TΩ
- Fixed or programmable test voltage from 40V to 10kV
- 5mA charging current
High Voltage Ohm-Check Neutral Resistance Tester
- Cable to clamp-on meter, 10’
- Cables between reels & neutral, 10’
- Line cord 10’ & #2 Ground Cable, 20’
Megger MGFL100 Battery Ground Fault Locator
- Alarms when the real fault is identified
- Direct measurement of resistance and stray capacitance
- Direct measurement of fault current and leakage current
Megger S1-568 Insulation Resistance Tester
- Resistance: 15 TΩ - 5 kV, 35 TΩ - 10 kV, 35 TΩ - 15 kV
- High Current: 6mA short circuit current
- Noise Rejection: 8 mA
General Radio 1864 Megohmmeter
Megger MIT510 Insulation Resistance Tester 5 kV
- CAT IV 600 V
- Mains or battery powered
- Digital/Analogue backlit display
AEMC 6417
- 47 - 800 Hz
- Stores up to 2000 measurements
- 50, 60, 128, or 2083 Hz (user selectable)
General Radio 1863 Megohmmeter
Fluke 1630 Earth Ground Clamp Meter
- A wide ground loop resistance range, from 0.025 Ω to1500 Ω, to satisfy all requirements
- Large jaw opening of 35 mm (1.38 in) for tests on ground conductors and/or equipotential bus bars
- Measurement of ground leakage current, from 0.2 mA to 1000 mA, without needing to disconnect - ideal for system troubleshooting
Fluke 1587 Insulation Multimeter
- Insulation test voltages 50 volts; 100 volts; 250 volts; 500 volts; 1,000 volts
- Live circuit detection prevents insulation test if voltage of more than 30 volts is detected
- Auto-discharge of capacitive voltage for added user protection
Fluke 1555 Insulation Resistance Tester
- Test voltages of up to 10 kV
- Cat III 1000V, CAT IV 600V safety rating
- Voltage breakdown detection alerts the user that voltage is present and gives the voltage reading up to 600V AC or DC for increased user safety
Fluke 1550B Megohmmeter
- Test voltages of 250V, 500 V, 1000 V, 2500 V, and 5000 V
- Capable of testing in 50V increments between 250V and 1000V and 100V increments between 1000V and 5000V
- Measures 0 to 1 Tera- ohms
Fluke 1520 Megohmmeter
- Three output voltages for insulation resistance testing: 250V, 500V, 1000V
- Insulation resistance testing up to 4000 Meg ohms; switches automatically to voltage measurement when voltage is greater than 30VAC or 30VDC.
- AC/DC voltage measurement up to 600V
AEMC 6470-B Ground Resistance Tester
- 4-Pole (4-Point) Fall-of-Potential measurement for very low resistance measurements with manual or automatic frequency selection and automatic lead compensation
- 3-Point Fall-of-Potential measurement
- 3-Point earth coupling measurement
AEMC 3730 Clamp-On Ground Resistance Tester
- Simple and fast clamp-on operation - no leads, no auxiliary rods or spacing requirements
- Direct reading of ground resistance from 1 ohms to 1200 ohms
- Direct reading of ground leakage current from 1 mA to 30 Arms
AEMC 3711 Clamp-On Ground Resistance Tester
- Simple and fast clamp-on operation - no leads, no auxiliary rods or spacing requirements. No need to disconnect neutral service
- Direct reading of ground resistance from 0.01Ω to 1200Ω
- Direct reading of continuity and ground loop resistance
AEMC 1060 1000V Megohmmeter
- True Megohmmeter
- Test voltage combinations of 50V, 100V, 250V, 500V and 1000V
- Insulation measurement to 4000GΩ (4TΩ)
AEMC 1050 Digital / Analog Megohmmeter | 1000 V
- Direct measurement of DAR and PI values
- Direct measurement of sample Capacitance
- Display of test voltage and run time
AEMC 6470 Multi-Function Ground Resistance Tester
- 3-Point Fall-of-Potential measurement with manual or automatic frequency selection
- 3-Point earth coupling measurement
- Automatic frequency scan from 40 Hz to 513 Hz for optimum test accuracy in electrically noisy environments
AEMC 6471 Ground Resistance Tester