| Probe Tip Diameter |
1.86 inch (±0.05 inch) |
| Probe Length |
35.0 inch (±0.5 inch) |
| Radiated PIM, 2x 2 |
PIM Probe will not generate IM3 > –90 dBm when the probe tip is placed 6 inches in front of a single dipole element antenna. PIM is measured as reverse IM at the antenna test port. (In practice, the PIM probe should not be placed closer than 1 wavelength to the front side of a directional panel antenna. In this condition, the band-pass filter may not have sufficient rejection to prevent erroneous measurements.) |
| Coupling Variation vs. Probe Orientation |
Signal variation is 5 dB or less (typical) when probe is rotated 90° with respect to a vertically oriented diode being radiated by PIM test tones. (Measurement is conducted with tip of probe located 1 inch from diode.) |
| RF Connector |
Type N, female |
| Rod Material |
Filament wound, epoxy tube |
| Handle |
Times Microwave TuffGrip® rubber handle |
| ROHS |
Compliant |
| Contents |
PIM Hunter probe and carrying case |
| European Union |
CISPR 11/EN 55011, IEC/EN 61000-4-2/3/4/5/6/8/11
Safety EN 61010-1:2010
RoHS Directive 2011/65/EU |
| Australia and New Zealand |
RCM AS/NZS 4417:2012 |
| South Korea |
KCC-REM-A21-0004 |