EMC Partner MIL-MG3 Military Test System
- Exceeds maximum test levels in MIL-STD-461
- One coupler for tests (CS115 & CS116)
- Test report data stored in MIL-MG3, accessible via USB or Ethernet
Solar 7399-2 2,500 Volt Spike Generator for MIL-STD-1399
- Repetitive spikes up to 2500 volts peak at two pulses per minute.
- Single non-synchronous spike actuated by a push button on the panel.
- Sync functions provide for placing the spike on the power frequency waveform of 50, 60 or 400 Hz power lines. The spike can be moved to any point of the sine wave from 0 to 360°
AE Techron DSR 100-200 | Pulse 2B and 4
- 4-Quadrant – Can source and sink current.
- ±80V – DC supply for 12V to 48V systems; meets 80V surge requirements.
- 300 kHz Sine – DC ripple tests for all major standards.
Montena PPG-E1-1200 Portable Pulse Generator for MIL-STD-188-125
- A wide operating range from 50 A to 1.2 kA
- Dedicated control software application for the configuration of the generator and the measurement equipment
- Battery powered, especially designed for tests onsite
Solar Electronics 7399-3 Spike Generator
- Repetitive spikes up to 2500 V peak at two pulses per minute
- Single non-synchronous spike actuated by a pushbutton on the panel
- Sync functions provide for placing the spike on the power frequency waveform of 50, 60 or 400 Hz power lines; the spike can be moved to any point on the sine wave from 0 to 360°
Solar 2654-2 Lightning Transient Generator System for DO-160
- The controller and power supply module
- Waveform timing
- The high voltage power supply
Solar 9354-1
- Panel mounted digital Voltmeter displays the open circuit discharge voltage
- Automatic or manual trigger for damped sinewave. Manual only for double exponential pulses
- Variable peak output voltage (adjustable from 0.1 to 100% of selected circuit discharge voltage
Teseq NSG 4060 Low Frequency Immunity Test System
- Signal generator and integrated power amplifier 15 Hz to 150 kHz
- Meets IEC / EN 61000-4-16 in combination with the Extension Unit
- Meets IEC / EN 61000-4-19 and other standards
AE Techron 7234 Audio Power Amplifier
- Bench-sized
- Single-phase
- Drop outs and surges as fast as 1.2µs
AE Techron 7228 Linear Power Amplifier
- Frequency Range: DC – 1 MHz
- Gain: 20V
- AC Power: 1000W RMS
Montena PG1275 Surge Generator
- Standard: MIL-STD-1275D
- Transients supported: imported and exported spikes imported and exported surges
- imported and exported spikes
California Instruments CSW5550 Programmable AC/DC Power Source
- Output: 5.5kVA, 0-156/312V, 3ph
- Frequency Range: 40Hz - 5kHz
- Input Power: 187/264Vrms (3 wire), 342/457Vrms (4 wire), 3ph
Tektronix TCP303
- Easy Current Measurements
- Probe Connects Directly to TDS Scope through TEKPROBE™ BNC Interface
- Split Core Construction for Easy Circuit Connection
Schloder CDG7000-75-10 Magnetic & Conducted Generator
- Frequency Range: 10 kHz - 250 MHz
- Output Power (Nominal): 75 W
- Gain: 51 dB nominal
Solar 7054-2B Spike Generator
- 0° to 360°
- Periodically 50, 60 or 400 Hz Sine Wave
- Provides output levels from 10 V to 400 V into 5 Ω. Delivers more than 300 kW peak into 0.5 Ω load
Tektronix TCPA300 Current Probe Amplifier
- DC to 100 MHz maximum bandwidth
- Automatic control and onscreen scaling and units
- AC/DC input coupling
EMC Partner IMU C-SHORT Common Mode Short Duration Testing Extension
- IEC 61000-4-16 Standard
- Testing capabilities that find conducted immunity
- Common mode extension
_17.png)
Prâna IP-DR250 Bulk Current Injection Probe
- Frequency Range: 10kHz - 400MHz
- Power: 500W (CW), Loss: -33... -6dB
- Inner Diameter: 1.72in (43.8mm)
Solar 9355-1 for MIL-STD-461D/E CS115
- Panel-mounted digital meters monitor the adjustable charged line voltage and pulse repetition rate.
- Adjustable pulse rate from 0.6 p.p.s. to 150 p.p.s., and manual triggering via front panel push button.
- Charged line output voltage adjustable from 1.0 V to >2000 V
AE Techron 3110 Standards Waveform Generator
- Includes a large library of Automotive and Aviation Standards’ test routines--complete list available as Supplemental Document under Datasheet on left
- Drag and drop interface makes it easy to modify existing tests or build new waveform sequences
- Loop entire tests or test sections; repeat loops with increments of up to four variables
PMM EMCL-35 10 kHz - 1 GHz EM Injection Clamp | 35mm Aperture
- Frequency Range: 10kHz - 1GHz
- Power: 100W, Typ. Coupling Factor: -3dB
- Inner Diameter: 1.38in (35mm)
Teseq NSG 4070B Conducted Immunity Test System
- Integrated signal generator 9 kHz – 1 GHz
- 3 power meter inputs 9 kHz – 1 GHz
- Integrated class A power amplifier module for different applications: 35 W, 150 kHz – 230 MHz; 40 W, 10 kHz – 400 MHz 45 W, 9 kHz – 1 GHz; 80 W, 150 kHz
Teseq NSG 4070C-80 Test System for Conducted and Radiated Immunity
- IEC & Automotive standards
- 80W, 150kHz - 230MHz amplifier
- 4kHz - 1 GHz signal generator / power meter
AE Techron 8302 RF Amplifier
- Part of the 8300 Series
- Revolutionary switch-mode design
- Wide bandwidth and flexible
Tektronix TCP0020 Current Probe
- Easy-to-use design
- DC to >50 MHz bandwidth
- Core jaw diameter of 5 mm (0.2 in)