Montena PG1275 Surge Generator Rentals

Montena PG1275 Surge Generator

The Montena PG1275 Surge Generator is specially designed for the test of the susceptibility to surges and spikes of military 28 Vdc electric circuits. The equipment allows performing the following tests according to MIL-STD 1275D of: imported and exported spikes, imported and exported surges. The surge voltages are supported up to 125 V and the spike charging voltage up to +/-500 V. The maximum permanent current of the 5 μH internal coil is 400 A dc. The pulse generator can be ordered with all the accessories in order to build the full test set-up basically consisting of batteries and an oscilloscope. The generator can be fully controlled by a computer through a RS232 or an USB interface.

Montena PPG-E1-1200 Portable Pulse Generator for MIL-STD-188-125

A wide operating range from 50 A to 1.2 kA
Dedicated control software application for the configuration of the generator and the measurement equipment
Battery powered, especially designed for tests onsite

Solar 2654-2 Lightning Transient Generator System for DO-160

The controller and power supply module
Waveform timing
The high voltage power supply

Solar Electronics 7399-3 Spike Generator

Repetitive spikes up to 2500 V peak at two pulses per minute
Single non-synchronous spike actuated by a pushbutton on the panel
Sync functions provide for placing the spike on the power frequency waveform of 50, 60 or 400 Hz power lines; the spike can be moved to any point on the sine wave from 0 to 360°

Solar 7399-2 2,500 Volt Spike Generator for MIL-STD-1399

Repetitive spikes up to 2500 volts peak at two pulses per minute.
Single non-synchronous spike actuated by a push button on the panel.
Sync functions provide for placing the spike on the power frequency waveform of 50, 60 or 400 Hz power lines. The spike can be moved to any point of the sine wave from 0 to 360°

Teseq NSG 4070B Conducted Immunity Test System

Amp Range: 150kHz - 230MHz (80W)
Sig Gen Range: 9kHz - 1GHz
3 Power Meter Ports

Solar 7054-2B Spike Generator

0° to 360°
Periodically 50, 60 or 400 Hz Sine Wave
Provides output levels from 10 V to 400 V into 5 Ω. Delivers more than 300 kW peak into 0.5 Ω load

Solar 2854-2 Spike Generator

Provides output levels from 10 V to more than 400 V into 5 Ω
Adjustable pulse position on AC lines relates the transient susceptibility to real time aspects of digital systems
Single pulse feature for controlled isolation of transient eects

EMC Partner MIL-MG3 Military Test System

Exceeds maximum test levels in MIL-STD-461
One coupler for tests (CS115 & CS116)
Test report data stored in MIL-MG3, accessible via USB or Ethernet

Solar 7054-1 Spike Generator for MIL-STD-461 CS106

Provides output levels from 10 volts to more than 600 volts into 5 ohms or less. Delivers more than 300 kw peak into 0.5 ohms load.
Adjustable pulse position on a.c. lines relates the transient susceptibility to real time aspects of digital systems.
Single pulse feature for controlled isolation of transient effects.

Solar 2854-1 Transient Generator

For MIL-STD-461F CS106 conducted transient susceptibility test
Adjustable pulse position on AC lines relates the transient susceptibility to real time aspects of digital systems
Single-pulse feature for controlled isolation of transient effects

Solar 7054-2 Spike Generator 600 V

10 V to 600 V Output
Delivers < 300 kW Peak to a .5 Ω Load
Pulse Position on AC Lines Adjustable - Relates Transient Immunity to Real Time Aspects

Solar 8282-1 Transient Pulse Generator

Provides outputs up to 600 volts peak amplitude for the 0.15, 5.0 and 10.0 S spikes into a five ohm resistive load (low source impedance).
A wide range of repetition rates allows spike injection in terms of the pulse rates of items being tested.
The single pulse feature enables controlled isolation of transient effects.

Solar 6552-1A 10 Hz - 100 kHz, 100 Watt Audio Amplifier

Input Voltage: 0.6 volt for maximum power output at 1000 Hz.
Input Impedance: 500-600 ohms.
Output Power: 100 watts at 1 KHz into 2.4 ohms.

Solar 6254-5S RFI Transient Generator

Spike Amplitude: Continuously adjustable from less than 10 volts to more than 250 volts peak.
Repetition Rate: Continuously adjustable from 0.5 to 500 p.p.s.
Rise Time: Less than 1.0 microsecond.