Related Products

Solar 2654-2 Lightning Transient Generator System for DO-160
- The controller and power supply module
- Waveform timing
- The high voltage power supply


Teseq NSG 4070B
- Integrated signal generator 9 kHz – 1 GHz
- 3 power meter inputs 9 kHz – 1 GHz
- Integrated class A power amplifier module for different applications: 35 W, 150 kHz – 230 MHz; 40 W, 10 kHz – 400 MHz 45 W, 9 kHz – 1 GHz; 80 W, 150 kHz


EMC Partner MIL-MG3 Military Test System
- Exceeds maximum test levels in MIL-STD-461
- One coupler for tests (CS115 & CS116)
- Test report data stored in MIL-MG3, accessible via USB or Ethernet


Montena PG1275 Surge Generator
- Standard: MIL-STD-1275D
- Transients supported: imported and exported spikes imported and exported surges
- imported and exported spikes


EM Test UCS 200N50 Automotive Transient Generator
- EFT/Burst: 25V – 1,000V ±10%
- 60V / 50A continuous, 100A @ 500 ms
- ISO 7637-2 Pulses 1, 2, 3A/3B, 6


EM Test VDS 200N100 Voltage Drop Simulator 60 V, 100 A
- Voltage up to 60 V
- Current up to 100A
- Bipolar-amplifier models available


AE Techron DSR 100-200 | Pulse 2B and 4
- 4-Quadrant – Can source and sink current.
- ±80V – DC supply for 12V to 48V systems; meets 80V surge requirements.
- 300 kHz Sine – DC ripple tests for all major standards.


Solar Electronics 7399-3 Spike Generator
- Repetitive spikes up to 2500 V peak at two pulses per minute
- Single non-synchronous spike actuated by a pushbutton on the panel
- Sync functions provide for placing the spike on the power frequency waveform of 50, 60 or 400 Hz power lines; the spike can be moved to any point on the sine wave from 0 to 360°


Montena PPG-E1-1200 Portable Pulse Generator for MIL-STD-188-125
- A wide operating range from 50 A to 1.2 kA
- Dedicated control software application for the configuration of the generator and the measurement equipment
- Battery powered, especially designed for tests onsite


Solar 7399-2 2,500 Volt Spike Generator for MIL-STD-1399
- Repetitive spikes up to 2500 volts peak at two pulses per minute.
- Single non-synchronous spike actuated by a push button on the panel.
- Sync functions provide for placing the spike on the power frequency waveform of 50, 60 or 400 Hz power lines. The spike can be moved to any point of the sine wave from 0 to 360°


EM Test LD 200N Load Dump Generator for ISO 7637
- Generates clipped load dump pulses (optional built-in module).
- Built-in 0.5 - 38 ohm source impedance, selectable in 0.1 ohm steps.


Solar 9354-1
- Panel mounted digital Voltmeter displays the open circuit discharge voltage
- Automatic or manual trigger for damped sinewave. Manual only for double exponential pulses
- Variable peak output voltage (adjustable from 0.1 to 100% of selected circuit discharge voltage


Solar 9354-2 Transient Generator for MIL-STD-461 and DO-160
- Panel-mounted digital voltmeter. Monitors the adjusted open circuit discharge voltage
- Pulse rates up to one pulse per second maximum (factory adjusted)
- Single pulse feature enables controlled isolation of transient effects


Hilo-Test CAR Test System 14
- Rise time variable 1 - 5µs.
- Vehicle voltages : 12V / 24V / 42V / 48V / 70V.
- Battery current: 50A / 100A / 200A.


EM Test PFM 200N100.1 Automotive Power Fail Simulator
- Switch for Power supply (100 A) and signal/data lines (2 A)
- Pulses E10 and E13 of the LV 124/LV 148 standard
- Bidirectional current direction


Teseq NSG 4060 Low Frequency Immunity Test System
- Signal generator and integrated power amplifier 15 Hz to 150 kHz
- Meets IEC / EN 61000-4-16 in combination with the Extension Unit
- Meets IEC / EN 61000-4-19 and other standards


AE Techron 3110 Standards Waveform Generator
- Includes a large library of Automotive and Aviation Standards’ test routines--complete list available as Supplemental Document under Datasheet on left
- Drag and drop interface makes it easy to modify existing tests or build new waveform sequences
- Loop entire tests or test sections; repeat loops with increments of up to four variables


Solar Electronics 9554 Variable Frequency Modules
- Variable frequency modules
- Comes in several configurations
- Specialized module for military and aerospace applications


California Instruments CSW5550 Programmable AC/DC Power Source
- Output: 5.5kVA, 0-156/312V, 3ph
- Frequency Range: 40Hz - 5kHz
- Input Power: 187/264Vrms (3 wire), 342/457Vrms (4 wire), 3ph


Solar 7054-2B Spike Generator
- 0° to 360°
- Periodically 50, 60 or 400 Hz Sine Wave
- Provides output levels from 10 V to 400 V into 5 Ω. Delivers more than 300 kW peak into 0.5 Ω load


Solar 8850-2 High Power Sweep Generator
- Manual or automatic frequency sweep from 30 Hz to 150 KHz
- Digital display of frequency and output voltage level or injected voltage level
- Remote sensing of voltage being injected into the Equipment Under Test


Solar 9355-1 for MIL-STD-461D/E CS115
- Panel-mounted digital meters monitor the adjustable charged line voltage and pulse repetition rate.
- Adjustable pulse rate from 0.6 p.p.s. to 150 p.p.s., and manual triggering via front panel push button.
- Charged line output voltage adjustable from 1.0 V to >2000 V


Hilo-Test CAR PG 2804 Load Dump Generator
- Load Dump Generator.
- Pulse #5 / Test A / Test B.
- Ri = 0.5 / 1 / 2 / 4 / 8 Ω


EM Test Autowave Arbitrary Generator
- Dual-Processor-Technology, 500kS/s sample rate
- 4-channel arbitrary generator
- 2-channel transient recorder


Teseq Mil-Std-461 CS114 10kHz - 400 MHz Conducted Susceptibility Test System
- Signal generation: NSG 4070-0
- Modulator: included in NSG 4070-0
- Power meter: 3x included in NSG 4070-0
