AE Techron DSR 100-200 | Pulse 2B and 4
- Frequency Range: DC - 250 kHz
- Output Current: 0A - 200A (Cont.)
- DO 160G, ISO 7637-2, MIL STD 461F
Montena PPG-E1-1200 Portable Pulse Generator for MIL-STD-188-125
- A wide operating range from 50 A to 1.2 kA
- Dedicated control software application for the configuration of the generator and the measurement equipment
- Battery powered, especially designed for tests onsite
Solar 2654-2 Lightning Transient Generator System for DO-160
- The controller and power supply module
- Waveform timing
- The high voltage power supply
Solar Electronics 7399-3 Spike Generator
- Repetitive spikes up to 2500 V peak at two pulses per minute
- Single non-synchronous spike actuated by a pushbutton on the panel
- Sync functions provide for placing the spike on the power frequency waveform of 50, 60 or 400 Hz power lines; the spike can be moved to any point on the sine wave from 0 to 360°
AE Techron 3110 Standards Waveform Generator
- DC-20kHz (DAC), DC-300kHz (Sine)
- 120VAC, 1.0VA service, 1Ø
- IEC 6100-4-16, ISO 7637, ISO 16750-2
Tektronix TCPA300 Current Probe Amplifier
- DC to 100 MHz maximum bandwidth
- Automatic control and onscreen scaling and units
- AC/DC input coupling
AE Techron 7234 Audio Power Amplifier
- DC - 1MHz
- 900W RMS
- 20V/V (Voltage Mode) or 6V/V (DIP Switch)
Solar 7399-2 2,500 Volt Spike Generator for MIL-STD-1399
- Repetitive spikes up to 2500 volts peak at two pulses per minute.
- Single non-synchronous spike actuated by a push button on the panel.
- Sync functions provide for placing the spike on the power frequency waveform of 50, 60 or 400 Hz power lines. The spike can be moved to any point of the sine wave from 0 to 360°
Solar 9354-2 Transient Generator for MIL-STD-461 and DO-160
- Panel-mounted digital voltmeter. Monitors the adjusted open circuit discharge voltage
- Pulse rates up to one pulse per second maximum (factory adjusted)
- Single pulse feature enables controlled isolation of transient effects
Montena PG1275 Surge Generator
- Standard: MIL-STD-1275D
- Transients supported: imported and exported spikes imported and exported surges
- imported and exported spikes
Tektronix TCP303
- Easy Current Measurements
- Probe Connects Directly to TDS Scope through TEKPROBE™ BNC Interface
- Split Core Construction for Easy Circuit Connection
Schloder CDG7000-75-10
- Amp Range: 10kHz - 250/400MHz (25/75W)
- Sig Gen Range: 9kHz - 1.2GHz
- 3 Ports
AE Techron 7228 Linear Power Amplifier
- Frequency Range: DC – 1MHz
- AC Power: 1000W RMS
- Gain: 20V
EMC Partner IMU C-SHORT Common Mode Short Duration Testing Extension
- IEC 61000-4-16 Standard
- Testing capabilities that find conducted immunity
- Common mode extension
_17.png)
Prâna IP-DR250 Bulk Current Injection Probe
- Frequency Range: 10kHz - 400MHz
- Power: 500W (CW), Loss: -33... -6dB
- Inner Diameter: 1.72in (43.8mm)
Solar 9354-1
- Panel mounted digital Voltmeter displays the open circuit discharge voltage
- Automatic or manual trigger for damped sinewave. Manual only for double exponential pulses
- Variable peak output voltage (adjustable from 0.1 to 100% of selected circuit discharge voltage
Teseq NSG 4070C-80 Test System for Conducted and Radiated Immunity
- Amp Range: 150kHz - 230MHz at 80W
- Sig Gen Range: 4kHz – 1GHz
- 3 Ports
Teseq NSG 4070B Conducted Immunity Test System
- Amp Range: 150kHz - 230MHz (80W)
- Sig Gen Range: 9kHz - 1GHz
- 3 Ports
Solar 8850-2 High Power Sweep Generator
- Manual or automatic frequency sweep from 30 Hz to 150 KHz
- Digital display of frequency and output voltage level or injected voltage level
- Remote sensing of voltage being injected into the Equipment Under Test
AE Techron 8302 RF Amplifier
- DC - 50kHz
- 2kW
- ISO 7637-2, ISO 16750-2
Solar 7054-2B Spike Generator
- 0° to 360°
- Periodically 50, 60 or 400 Hz Sine Wave
- Provides output levels from 10 V to 400 V into 5 Ω. Delivers more than 300 kW peak into 0.5 Ω load
Tektronix TCP0020 Current Probe
- Easy-to-use design
- DC to >50 MHz bandwidth
- Core jaw diameter of 5 mm (0.2 in)
Solar Electronics 9554 Variable Frequency Modules
- Variable frequency modules
- Comes in several configurations
- Specialized module for military and aerospace applications
Solar 8282-1 Transient Pulse Generator
- Provides outputs up to 600 volts peak amplitude for the 0.15, 5.0 and 10.0 S spikes into a five ohm resistive load (low source impedance).
- A wide range of repetition rates allows spike injection in terms of the pulse rates of items being tested.
- The single pulse feature enables controlled isolation of transient effects.
EMC Partner MIL-MG3 Military Test System
- Exceeds maximum test levels in MIL-STD-461
- One coupler for tests (CS115 & CS116)
- Test report data stored in MIL-MG3, accessible via USB or Ethernet