Montena PPG-E1-1200 Portable Pulse Generator for MIL-STD-188-125
- A wide operating range from 50 A to 1.2 kA
- Dedicated control software application for the configuration of the generator and the measurement equipment
- Battery powered, especially designed for tests onsite
Solar 2654-2 Lightning Transient Generator System for DO-160
- The controller and power supply module
- Waveform timing
- The high voltage power supply
Solar Electronics 7399-3 Spike Generator
- Repetitive spikes up to 2500 V peak at two pulses per minute
- Single non-synchronous spike actuated by a pushbutton on the panel
- Sync functions provide for placing the spike on the power frequency waveform of 50, 60 or 400 Hz power lines; the spike can be moved to any point on the sine wave from 0 to 360°
Montena PG1275 Surge Generator
- Standard: MIL-STD-1275D
- Transients supported: imported and exported spikes imported and exported surges
- imported and exported spikes
Solar 7399-2 2,500 Volt Spike Generator for MIL-STD-1399
- Repetitive spikes up to 2500 volts peak at two pulses per minute.
- Single non-synchronous spike actuated by a push button on the panel.
- Sync functions provide for placing the spike on the power frequency waveform of 50, 60 or 400 Hz power lines. The spike can be moved to any point of the sine wave from 0 to 360°
Teseq NSG 4070B Conducted Immunity Test System
- Amp Range: 150kHz - 230MHz (80W)
- Sig Gen Range: 9kHz - 1GHz
- 3 Power Meter Ports
Solar 7054-2B Spike Generator
- 0° to 360°
- Periodically 50, 60 or 400 Hz Sine Wave
- Provides output levels from 10 V to 400 V into 5 Ω. Delivers more than 300 kW peak into 0.5 Ω load
Solar 2854-2 Spike Generator
- Provides output levels from 10 V to more than 400 V into 5 Ω
- Adjustable pulse position on AC lines relates the transient susceptibility to real time aspects of digital systems
- Single pulse feature for controlled isolation of transient eects
Solar 8282-1 Transient Pulse Generator
- Provides outputs up to 600 volts peak amplitude for the 0.15, 5.0 and 10.0 S spikes into a five ohm resistive load (low source impedance).
- A wide range of repetition rates allows spike injection in terms of the pulse rates of items being tested.
- The single pulse feature enables controlled isolation of transient effects.
EMC Partner MIL-MG3 Military Test System
- Exceeds maximum test levels in MIL-STD-461
- One coupler for tests (CS115 & CS116)
- Test report data stored in MIL-MG3, accessible via USB or Ethernet
Solar 7054-1 Spike Generator for MIL-STD-461 CS106
- Provides output levels from 10 volts to more than 600 volts into 5 ohms or less. Delivers more than 300 kw peak into 0.5 ohms load.
- Adjustable pulse position on a.c. lines relates the transient susceptibility to real time aspects of digital systems.
- Single pulse feature for controlled isolation of transient effects.
Solar 2854-1 Transient Generator
- For MIL-STD-461F CS106 conducted transient susceptibility test
- Adjustable pulse position on AC lines relates the transient susceptibility to real time aspects of digital systems
- Single-pulse feature for controlled isolation of transient effects
Solar 7054-2 Spike Generator 600 V
- 10 V to 600 V Output
- Delivers < 300 kW Peak to a .5 Ω Load
- Pulse Position on AC Lines Adjustable - Relates Transient Immunity to Real Time Aspects
Montena PG1275F Surge Generator
- 16A max. (400A - DM400 Diode)
- Injected voltage spikes, injected voltage surge
- < 45 mΩ (DC) + 300 µH
California Instruments Tahoe | TA0045A1 Power Supply | 45 kVA
- Output: 45kVA, 0-166/333Vrms, 1/3ph
- Frequency Range: 16Hz - 905Hz
- Input Power: 208/600VAC, 3ph
Montena POG-CS116-9 Transient Generator 10 kHz - 100 MHz
Montena PG1275E Surge Generator for MIL-STD 1275E
- Generator can be fully controlled by a computer through a RS232 or an USB interface
Montena PG-CS115 Pulse Generator 5 kV
Teseq NSG 4060 Low Frequency Immunity Test System
- Signal generator and integrated power amplifier 15 Hz to 150 kHz
- Meets IEC / EN 61000-4-16 in combination with the Extension Unit
- Meets IEC / EN 61000-4-19 and other standards
California Instruments MX Compliance Test System Series
- Direct PC bus access data acquisition system provides the required sampling rate and resolution to meet IEC 61000-4-7 measurement requirements and supports high speed data transfers, unlike competing
- PC based Harmonic and Flicker test software provides real-time full color data display updates and continuous PASS/FAIL monitoring.
- Automatic calculation of the maximum permissible system impedance Zsys, using the Zref and measured Flicker parameters, as required per EN/IEC 61000-3-11.
CA Instruments MX90 Power Source and Compliance Test System
- Output: 90kVA, 0-150/300V, 3ph
- Frequency Range: 16Hz - 1000Hz
- Input Power: 208/480 ±10%VAC, 3ph
California Instruments MX45 AC Power Source
- Output: 45kVA, 0-150/300V, 3ph
- Frequency Range: 40 - 1000Hz
- Input Power: 208/480 ±10%VAC, 3ph
EMC Partner MIL3000 Military Test System
- Exceeds maximum test levels in MIL-STD-461
- One coupler for tests (CS115 & CS116)
- Test report data stored in MIL3000, accessible via USB or Ethernet
Teseq Mil-Std-461 CS114 10kHz - 400 MHz Conducted Susceptibility Test System
- Signal generation: NSG 4070-0
- Modulator: included in NSG 4070-0
- Power meter: 3x included in NSG 4070-0
EMC-Partner MIG2000-6 Modular Impulse Generator
- Solid state impulse switch and solid state polarity change (no mechanical switch, no spark gaps or tubes) - advantages: low jitter, no high frequency switching noise,
- Microprocessor menu controlled, printer port and RS232 remote control
- Safety in accordance with VDE 0104 (safety circuit, connector for warning lamp)