Fluke TN2100 Copper Terminator Far End Terminating Device

Fluke TN2100 Copper Terminator Far End Terminating Device
Enlarge Image
Fluke TN2100 Copper Terminator Far End Terminating Device Fluke TN2100 Copper Terminator Far End Terminating Device Fluke TN2100 Copper Terminator Far End Terminating Device
Request Quote Print Page
Datasheet Accessory Kit

The Fluke Networks Model TN2100 Enhanced Terminator is an accessory device to the Fluke Networks 990DSL CopperPro Loop Tester (with Ver. 3.00 or later software), for terminated testing applications. The TN2100 provides test terminations and tones for the purpose of both POTS and DSL service qualification. It is connected to the far end of the cable and automatically controlled over the test pair by the CopperPro. It employs DTMF signaling in a closed-loop fashion, responding to each CopperPro command with an acknowledgement tone.

 

Features:

  • 2 Test Pair Connections
  • C.O. Isolate / Bypass Pair Connection
  • Open Circuit
  • Tracing Tone
  • Ring-Tip Short
  • Ring Ground
  • Tip Ground
  • Tip & Ring Ground
  • Quiet & Long. Balance Terminations
  • VF Single Tones
  • VF SmartTone (Composite 100-tone set)
  • Wideband Single Tones
  • Wideband Longitudinal Tones
  • Wideband Composite Tone-sets
 

Specifications:

Tracing Tone Frequency: 577 Hz (0.5 S on, 0.5 S off)
Voltage Rating: 250 VDC 150 VAC
AC Input Impedance: >100 Meg ohms (During Open Ckt.)
DC Input Impedance: >100 Meg ohms (During Open Ckt.)
Strap Resistance: < 0.1 ohms DC (Excluding test leads)
Storage Temperature: -40 to +158 °F (-40 to +70 °C)
Operating Temperature: 0 to +140 °F (-18 to +60 °C)
Weight: 8.6 oz. w / Battery (244 g.)
Tracing Tone Level: > 4 Vpp, no load (Metallic)
VF Single Tones: 0 dBm ± 0.5 dB 100 Hz - 20 kHz
VF Smart Tone -13.4 dBm ± 0.5 dB 300 - 3900 Hz
WB Single Tones: 0 dBm ± 0.75 dB 10 kHz - 1200 kHz
WB Composite Tone-sets Preset level / tone 8 kHz – 1104 kHz
Tone Output Impedance: 100, 135, 600, 900Ω