Rohde & Schwarz FSW85 Spectrum Analyzer
- Frequency Range: 2Hz - 85GHz
- Phase noise: –137 dBc/Hz
- DANL: –174 dBm/Hz
Rohde & Schwarz FSWP Phase Noise Analyzer & VCO Tester
- 1 MHz - 50 GHz frequency range
- Phase noise & spectrum analysis
- High sensitivity
Tektronix RSA6114B Spectrum Analyzer | 9 kHz - 14 GHz
- 20 dBm 3rd order intercept at 2 GHz, typical
- Displayed average noise level –151 dBm/Hz at 2 GHz (–167 dBm/Hz, preamp on, typical) enables low-level signal search
- Revolutionary DPX displays transients with a minimum event duration of 3.7 μs
Rohde & Schwarz FSP38 Spectrum Analyzer | 9 kHz - 40 GHz
- 15 minutes warm-up time at ambient temperature
- specified environmental conditions met, calibration cycle and total calibration
- Data without tolerances: typical values only
Tektronix RSA5126A Real-Time Spectrum Analyzer
- Frequency Range 1 Hz to 26.5 GHz.
- Trigger Modes: Free Run, Triggered, FastFrame.
- Level Range 0 dB to –100 dB from reference level.
Anritsu S362E Site Master Cable & Antenna Analyzer
- Cable & Antenna Analyzer: 2 MHz to 6 GHz
- Spectrum Analyzer: 9 kHz - 6 GHz
- Accuracy: ± 1.5 ppm, <±50 ppb with GPS on
Keysight E7405A
- 1 Hz to 5 MHz
- +12.5 dBm TOI
- Measurement rate: ≥40/sec
Anritsu MS2726C Handheld Spectrum Analyzer
- Measure occupied bandwidth, channel power, ACPR, and C/I
- Dynamic Range of >104 dB in 1 Hz RBW
- Phase Noise of –100 dBc/Hz @ 10 kHz offset at 1 GHz
Tektronix RSA518A Real-Time Spectrum Analyzer
- 9 kHz to18.0 GHz frequency range covers a broad range of analysis needs
- 40 MHz acquisition bandwidth enables real time analysis for transient capture and vector analysis
- High speed full-span sweeps (70 GHz/sec) for fast setup and discovery
Anritsu S331L Site Master Handheld Cable & Antenna Analyzer
- Frequency Range: 2MHz - 4GHz
- Frequency Accuracy: ≤ ±5ppm @25°C
- Frequency Resolution: 1kHz
Rohde & Schwarz ZVH8 Cable and Antenna Analyzer
- Frequency range from 100 kHz to 3.6 GHz or 8 GHz
- 100 dB (typ.) dynamic range for filter and antenna isolation measurements
- Built-in DC voltage supply (bias) for active components such as amplifiers
Narda SignalShark 3310 Real-Time Handheld Spectrum Analyzer
- Frequency range: 8 kHz - 8 GHz
- Scan rate: > 50 GHz
- Real-time instantaneous bandwidth: 40 MHz
Anritsu MS2713E Handheld Spectrum Analyzer
- Spectrum Analyzer: 9 kHz – 6 GHz
- Interference Analyzer with Interference Mapping
- High Accuracy Power Meter, 2-port Transmission Measurements
Keysight FieldFox N9923A Network Analyzer (Agilent N9923A)
- Built-in QuickCal technology enables calibration without a cal kit
- Best measurement stability over time and temperature
- Industry´s only handheld network analyzer with MIL PRF 28800F Class 2 compliance with no exceptions
Rohde & Schwarz PR100 Portable Receiver
- Ergonomic and rugged design for portable use
- Detection of unknown signals
- Frequency scan and memory scan
Anritsu MS2724C Spectrum Master Handheld Spectrum Analyzer
- LTE, TD-LTE
- GSM/EDGE
- W-CDMA/HSPA+
Rohde & Schwarz FSH18 10 MHz - 18 GHz Spectrum Analyzer
- Frequency range of 10 MHz to 18 GHz
- Reference Level -80dBm to +20dBm
- TOI typ. 7 dBm
Stanford Research Systems SR785 Dynamic Signal Analyzer
- DC to 102.4 kHz bandwidth
- 90 dB dynamic range
- 145 dB dynamic range in swept-sine mode
Rohde & Schwarz FSH8 Spectrum Analyzer 9 kHz - 8 GHz
- Frequency range from 9 kHz to 20 GHz
- High sensitivity (< –141 dBm (1 Hz), with preamplifier < –161 dBm (1 Hz))
- 20 MHz demodulation bandwidth for analyzing LTE signals
Keysight N9342C Handheld Spectrum Analyzer (HSA), 7 GHz
- AM/FM Tune and Listen
- Analog Demodulation
- Field Strength Measurement
Tektronix RSA306B USB Real-Time Spectrum Analyzer | 9 kHz - 6.2 GHz
- Full-featured spectrum analysis capability with included Tektronix SignalVu-PC™ software
- 17 spectrum and signal analysis measurements standard
- Options for mapping, modulation analysis, WLAN, LTE, and Bluetooth standards support, pulse measurements, playback of recorded files, Signal Survey, and frequency/phase settling
Rohde & Schwarz FSH313 Handheld Spectrum Analyzer w/ Tracking Generator
Anritsu S361E Site Master Handheld Cable & Antenna Analyzer
- Cable and Antenna Analyzer: 2 MHz – 6 GHz
- Return Loss, VSWR, Cable Loss, Distance-To-Fault, Smith Chart, 1-Port Phase
- Field-proven design: Four-hour battery life, rugged, compact, lightweight, daylight viewable display
Keysight N9320B RF Spectrum Analyzer | 9 kHz - 3 GHz
- Minimum non-zero span sweep time: < 10 ms
- Resolving power RBW: 10 Hz to 1 MHz
- Sensitivity DANL: -130 dBm, -148 dBm with preamp on
Keysight N9320A RF Spectrum Analyzer | 9 kHz – 3 GHz
- Fast measurement speed - best for mass production manufacturing tests, service and repair tasks
- Light weight and portable - good for field installation and maintenance tasks
- Full function spectrum analyzer with an affordable price - fits your tight budget and helps you reduce costs