Related Products

Haefely PSURGE 30.2 Surge Test System | 30 kV / 30 kA
- Up to 30 kV impulse voltage
- Up to 30 kA impulse current
- automatic polarity switching


Haefely AXOS8 Compact Conducted Immunity Test System
- 0.2 – 5.0 kV ±10% at coaxial output
- 50 Ohms
- 5 ns ±30%


Haefely AXOS5 Compact Immunity Test System
- Easy to operate with manual and automated test modes, software assisted test preparation
- Pre-defined test routines and visual aided test setups
- Economic & efficient touch screen guarantees reduction of time and effort


EMC Partner IMU-MGE Conducted Immunity Test System
- Surge / CWG 4kV / 5 kV / 6kV / 8kV
- Ring Wave 6kV / 8kV
- EFT 4kV / 5kV / 6kV / 7kV


Thermo Keytek ECAT E521
- AC CDN for single-phase lines to 480V, 32A
- Surge Repetition Rate 1 shot/30 seconds @ <=10kV 1 shot/minute @ >10kV
- Open-Circuit Voltage: 1.2/50µs, 200V to 20.2kV ±10%


Haefely PSURGE 8000 Surge Platform Test System
- Built according to IEC/EN 61000-4-5 Ed. 1 & 2 and ANSI C62.41/45
- 1.2/50 µs open circuit up to 7.4 kV
- 8/20 µs short circuit up to 3.7 kA


EMC Partner IMU3000 Immunity Tester
- 7” Colour touch panel
- Rotary knob for navigation and data entry
- EPOS (EMC PARTNER Operating System) a new concept in graphical user interface


Teseq CDN 3063-S100 3-Phase Coupling/Decoupling Network
- Three phase models with broad current range up to 100 A
- Fully automated surge and/or burst coupling
- IEC and ANSI coupling methods


M Precision Laboratories EMCPro PLUS EMC Test System
- Portable, mid-range EMC test system
- Resident capabilities for compliance testing to 6 IEC/EN standards
- Addresses ANSI/IEEE C62.41, ITU, ETSI, & UL 864 standards


Thermo Keytek ECAT E103 Control Center
- Virtual Front Panel™ retains key operating parameters during set up & testing
- Multi-level system interlock architecture provides maximum safety
- Single output port/instant mode switching


Powerside IPC-480V-200A Industrial Power Corruptor
- High power handling up to 480 Vrms nominal, 200 amps continuous
- Creates voltage sags and swells, from 0% to 125% of nominal, from 1 cycle to 30 seconds
- Creates voltage sags and swells, from 0% to 125% of nominal, from 1 cycle to 30 seconds


EMC Partner IMU-MGS Conducted Immunity Generator
- One touch parameter editing in run state
- Impulse stability over long periods
- Intuitive multi touch graphical interface


Teseq NSG 3060 Transient Generator
- Modular, expandable system
- Surge voltage to 6.6 kV for overtesting
- Easy to use 7" color touch screen


NoiseKen INS-4040 Impulse Noise Simulator
- 0.01~4.00kV ±10%
- 50 Ω Load, 10 V Step
- < 1 ns Rise Time


Haefely PLINE 1610 Voltage / Interruption Tester for IEC 61000-4-11
- Totally reproducible test results
- Fully automated, time saving design
- Integration in a full EMC test system


EM Test NX5 Multifunctional Test Generator
- Small transient generator with 7" color touch screen
- IEC 61000-4-4 | Burst testing, 5.5kV
- IEC 61000-4-5 | Surge testing, 5.0kV


Pacific Power EPTS-100A-3 Electronic Power Transfer Switch
- 3-Phase
- 100A / Ph
- Accuracy < 0.25%


Powerside PSL-IPC-240V-25A Industrial Power Corruptor
- High power handling up to 240Vrms nominal, 50 amps continuous
- Creates voltage sags and swells, from 0% to 125% of nominal, from 1 cycle to 30 seconds
- Creates voltage sags and swells, from 0% to 125% of nominal, from 1 cycle to 30 seconds


Pacific Power EPTS-32A-3 Electronic Power Transfer Switch
- 3-Phase
- 32 A Per Phase
- Full compliance for 61000-4-11 / 4-34


Noiseken INS-4020 Noise Simulator
- Automatic ramp operation for output voltage, phase angle and repetition period
- Floating output
- Coupling mode selection by plugging the supplied coaxial connector to the selected port


Teseq NSG 3150 Combination Wave Surge Generator | 15 kV
- Surge voltage up to 15 kV
- CDN range: Single & Three Phase, up to 63 A, 690 VAC, 1000 VDC
- Safest 15 kV connector type on the market


Teseq CDN 3083-B100 EFT/Burst Coupling/Decoupling Network
- 690 VAC, 1000 VDC
- Up to 8.8 kV burst pulses
- 100 A three-phase EFT / burst CDN


Teseq NSG 3025 Burst Generator
- Pulse form 5/50ns ±30% (50Ω)
- Pulse amplitude: 200 V to 4.8 kV ±10% (open circuit)
- Internal CDN: Single phase, in accordance with IEC 1000-4-4


EMC Partner SRC16-1P Single Phase Dip Transformer
- Single phase dip transformer
- Designed to perform dips tests according to IEC 61000-4-11
- Accessory used with the EMC Partner IMU3000 or EMC Partner IMU4000


Haefely / Bellcore 1089 Lightning Test System
- Full hybrid waveforms according to the lastest GR-1089 Core section 4
- 1st and 2nd level lightning surges
- Integrated automatic coupling for 2 and 4 wire telecom system
