Related Products
EMC Partner CDN-A-8-200 Coupling-Decoupling Network | 1500 VDC , 200 A
- Multicolor LED coupling path indication
- Up to 1500 VDC EUT voltage
- Ready for EV and railway testing
Teseq CDN 3083-S100 CDN | 3 Ph, 100 A, 690 V
- 100 Amps per phase with generous overload capacity
- For EUT power supplies up to 620 Volts
- Complies with IEC/EN 61000-4-5 and ANSI C62.45
Teseq CDN 3063-S100 3-Phase Coupling/Decoupling Network
- Three phase models with broad current range up to 100 A
- Fully automated surge and/or burst coupling
- IEC and ANSI coupling methods
Teseq CDN HSS-2 for Unshielded Symmetrical High Speed Communication Lines
- CDN for 1.2/50 μs pulse as per IEC 61000-4-5/Ed.3/77B/674A/CD:2012-05
- CDN for up to 8 wire unshielded twisted pair (UTP)
- Coupling to 1, 2 or 4 pairs
Haefely FP-SURGE 100M2 Coupling/Decoupling Network for Surge
- Combination wave 1.2/50us - 8/20us
- Ring wave 100kHz
- 8kV impulse voltage
Haefely FP-COMB 63 Combined Automatic 3-Phase Coupling / Decoupling Network
- 0.2 – 5.0 kV ±10% at coaxial output
- 5 kV
- Up to 690 V AC | 50/60 Hz, 16, 7 Hz, DC
Teseq CDN3153-S63 Coupling/Decoupling Network
- Pulse voltage: ±0.5 - 15kV (1V steps)
- Pulse current: ±0.25A - 7.5kA
- CDN range: 690V, 63A, 3Ø
EMC Partner CDN UTP8 ED3 Coupling/Decoupling Network
Haefely FP-COMB 32 Coupling/Decoupling Network
- Surge Combination Wave, 1.2/50us - 8/20us
- Ring Wave, 100kHz
- Electrical Fast Transient (EFT) / Burst
Teseq CDN 163 EFT / Burst Coupling Network
- 3-phase coupling network
- For AC and DC up to 100A per channel
- Short-term overstress capability
EM Test ACC Automotive Coupling Clamp
- An automotive coupling clamp
- Constructed with precision
- Up to 40 mm diameter cables
Teseq CDN 118-M Telecom Line Coupling/Decoupling Network
- Telecom line surge testing
- Complies with IEC/EN 61000-4-5
Teseq CDN 3083-B100 EFT/Burst Coupling/Decoupling Network
- 690 VAC, 1000 VDC
- Up to 8.8 kV burst pulses
- 100 A three-phase EFT / burst CDN
EMC Partner CDN-A-8-32 Coupling-Decoupling Network
- Unique capabilities
- Excellent decoupling
- Highest EUT voltage supported
Teseq (Schaffner) KEMA 801A Decoupling Clamp
- Decoupling Network/ RF attenuation clamp
- As specified in IEC/EN 61000-4-6
- Very efficient coupling
Teseq CDN3063-C32 Coupling/Decoupling Network
- 3-phase models with broad current range
- Fully automated surge and burst coupling
- IEC and ANSI coupling methods
Haefely PCD126A Telecom CDN
- Combination wave 1.2/50 us - 8/20 us impulse
- Serial resistor 40 Ohm included
- Up to 4 wires can be tested
Keysight N4690D-003 ECal Microwave Electronic Calibration Module, 18 GHz
- Precision 2-port microwave ECal module with high accuracy
- Broad choice of solutions (frequency and connector types)
- Frequency coverage from DC to 67 GHz
Noiseken CA-806 Coupling Adapter
- Input voltage: 2000V max.
- Input pulse width: 50ns - 1μs
- Terminator: Built-in 50 ohm terminator
Thermo Keytek CM-3CD-SRG 3 Phase Surge Coupler | 32A
- Semi-automatic operation when used with Thermo KeyTek’s CEMASTER or EMCPro simulators reduces the possibility of test sequence errors by prompting the user to make coupling mode selections
- Pre-programmed IEC test routines save time and decrease the potential for human error
- Ergonomic design provides maximum flexibility for operating from a table top or within a 19-inch rack.
AH Systems SAC-18G Meter Low-Loss Cable
- Frequency Range: DC - 18 GHz
- Impedance: 50 Ω
- Time Delay: 1.2 nS/ft
Haefely IP4B Capacitive Coupling Clamp
- Designed as per IEC 61000-4-4 Edition 3
- EFT/Burst testing of signal and data lines
- For cable diameter from 4 – 40 mm
Teseq CDN 117 Data Line Coupling/Decoupling Network
- Telecom line surge testing
- Complies with IEC/EN 61000-4-5
Amplifier Research DC3010A Dual Directional Coupler 10 kHz - 1 GHz
- High power, ultra-broadband dual directional coupler
- Excellent performance characteristics over a range of more than 14 octaves
- Frequency range of 10 kHz to 1 GHz
AH Systems SAC-40G Low-Loss Cable | DC - 43 GHz
- Frequency range from DC to 40 GHz
- Individually calibrated
- Precision N, SMA, 2.9 mm type connectors