Tektronix RSA6114B Spectrum Analyzer | 9 kHz - 14 GHz
- 20 dBm 3rd order intercept at 2 GHz, typical
- Displayed average noise level –151 dBm/Hz at 2 GHz (–167 dBm/Hz, preamp on, typical) enables low-level signal search
- Revolutionary DPX displays transients with a minimum event duration of 3.7 μs
Keysight E7405A | 9 kHz – 26.5 GHz
- 1 Hz to 5 MHz (including 200 Hz, 9 kHz, 120 kHz, 1 MHz EMI BW)
- +12.5 dBm TOI
- ≤150 dBm displayed average noise level (DANL)
Rohde & Schwarz FSH18 10 MHz - 18 GHz Spectrum Analyzer
- Frequency range of 10 MHz to 18 GHz
- Reference Level -80dBm to +20dBm
- TOI typ. 7 dBm
Rohde & Schwarz FSP38 Spectrum Analyzer | 9 kHz - 40 GHz
- 15 minutes warm-up time at ambient temperature
- specified environmental conditions met, calibration cycle and total calibration
- Data without tolerances: typical values only
Tektronix RSA5126A Real-Time Spectrum Analyzer
- Frequency Range 1 Hz to 26.5 GHz.
- Trigger Modes: Free Run, Triggered, FastFrame.
- Level Range 0 dB to –100 dB from reference level.
Wavecrest SIA 3000 Signal Integrity Analyzer
- Infiniband - Test to compliance on all channels simultaneously at speeds up to 4.5Gb/s per channel
- Rambus DRCG - Perform full DRCG validation in seconds
- Fibre Channel and Gigabit Ethernet - Test to compliance on all patterns and all channels simultaneously
Tektronix RSA306 USB Real Time Spectrum Analyzer
- 9 kHz to 6.2 GHz frequency range
- ACER Laptop with pre-installed SignalVU-PC software included
- +20 dBm to -160 dBm measurement range
Anritsu MS2726C Handheld Spectrum Analyzer
- Measure occupied bandwidth, channel power, ACPR, and C/I
- Dynamic Range of >104 dB in 1 Hz RBW
- Phase Noise of –100 dBc/Hz @ 10 kHz offset at 1 GHz
Keysight N9951A FieldFox Handheld Microwave Analyzer
- Standard model includes cable and antenna analyzer.
- Save time by measuring DTF and TDR in the same sweep.
- Measure all four S-parameters simultaneously.
Narda SignalShark 3310 Real-Time Handheld Spectrum Analyzer | 8 kHz to 8 GHz
- Extremely high sweep rate of up to 40 GHz/s
- 40 MHz real-time instantaneous bandwidth
- High time resolution spectrogram
Tektronix RSA518A Real-Time Spectrum Analyzer
- 9 kHz to18.0 GHz frequency range covers a broad range of analysis needs
- 40 MHz acquisition bandwidth enables real time analysis for transient capture and vector analysis
- High speed full-span sweeps (70 GHz/sec) for fast setup and discovery
Anritsu MS2713E Handheld Spectrum Analyzer
- Spectrum Analyzer: 9 kHz – 6 GHz
- Interference Analyzer with Interference Mapping
- High Accuracy Power Meter, 2-port Transmission Measurements
Rohde & Schwarz PR100 Portable Receiver
- Ergonomic and rugged design for portable use
- Detection of unknown signals
- Frequency scan and memory scan
Anritsu MS2724C Spectrum Master Handheld Spectrum Analyzer
- LTE, TD-LTE
- GSM/EDGE
- W-CDMA/HSPA+
Stanford Research Systems SR785 Dynamic Signal Analyzer
- DC to 102.4 kHz bandwidth
- 90 dB dynamic range
- 145 dB dynamic range in swept-sine mode
Rohde & Schwarz FSH8 Spectrum Analyzer 9 kHz - 8 GHz
- Frequency range from 9 kHz to 20 GHz
- High sensitivity (< –141 dBm (1 Hz), with preamplifier < –161 dBm (1 Hz))
- 20 MHz demodulation bandwidth for analyzing LTE signals
Tektronix RSA306B USB Real-Time Spectrum Analyzer | 9 kHz - 6.2 GHz
- Full-featured spectrum analysis capability with included Tektronix SignalVu-PC™ software
- 17 spectrum and signal analysis measurements standard
- Options for mapping, modulation analysis, WLAN, LTE, and Bluetooth standards support, pulse measurements, playback of recorded files, Signal Survey, and frequency/phase settling
Rohde & Schwarz FSH313 Handheld Spectrum Analyzer w/ Tracking Generator
Keysight N9320B RF Spectrum Analyzer | 9 kHz - 3 GHz
- Minimum non-zero span sweep time: < 10 ms
- Resolving power RBW: 10 Hz to 1 MHz
- Sensitivity DANL: -130 dBm, -148 dBm with preamp on
Keysight N9320A RF Spectrum Analyzer | 9 kHz – 3 GHz
- Fast measurement speed - best for mass production manufacturing tests, service and repair tasks
- Light weight and portable - good for field installation and maintenance tasks
- Full function spectrum analyzer with an affordable price - fits your tight budget and helps you reduce costs
Tektronix RSA6000 Series Spectrum Analyzers
- High-performance spectrum analysis Fully preselected and image free at all times for maximum dynamic range at any acquisition bandwidth Fastest high-resolution sweep speed: 1 GHz sweep
- Fully preselected and image free at all times for maximum dynamic range at any acquisition bandwidth
- Fastest high-resolution sweep speed: 1 GHz sweep in 10 kHz RBW in less than 1 second
Tektronix RSA5000 Series Real-Time Spectrum Analyzers
- DPX® Live RF spectrum display
- Triggering expertise
- Seamless data capture
Rohde & Schwarz FSL Series | 9 kHz – 3/6/18GHz
- Frequency range 9 kHz to 3 GHz, 6 GHz or 18 GHz
- Models with and without tracking generator
- Signal analysis bandwidth of 28 MHz
Anritsu MS2038C VNA Master & Spectrum Analyzer | 5 kHz to 20 GHz
- 2-port, 2-path, fully-reversing VNA
- S-parameters measured with a single connection
- 350 μsec per data point
Keysight 35670A FFT Dynamic Signal Analyzer
- Accuracy: ±30 ppm (.003%)
- Source Impedance: 50 Ω
- Dynamic: 90dB | Swept-sine: 130dB