Electrical: Industrial Electrical Testing

Electrical Test Equipment for commissioning and maintaining substations, power transformers, switchgear and high voltage power lines. Rent power analyzers for energy studies, Hart and Fieldbus process loop controllers (PLC) and calibrators, ground resistance testers, circuit breaker test, AC DC and VLF high pot, cable fault locators, motor surge testers, oil dielectric testers, motor wire resistance, Meggers/Megohmmeters, protective relay test sets, primary current injection, thumpers, TTR transformer turn ratio, thermal imagers, and more.
  • Cable fault testing, or cable fault location, is the process of identifying periodic or insulation faults in underground cables for electrical...

  • A current transformer test set identifies potentially disastrous current transformer faults, preventing the primary current from overwhelming...

  • VLF, or Very Low Frequency testers, are used to conduct VLF Withstand Tests. These tests are typically carried out on a frequency between 0.1 Hz...

  • Insulation and ground testing are both essential to electrical maintenance. Electrical insulation begins to age as soon as it's made, and poor...

  • Motor testing is performed on motors to diagnose what is causing them to run hot, fail to start, continuously trip their overcurrent device or...

  • Oil dielectric testers provide measurements of the breakdown voltage of insulating oils used in electrical equipment like transformers, switchgear,...

  • Partial discharges (or PD for short) are the small electrical sparks found within the insulation of medium to high voltage electrical systems...

  • Power factor and tan delta testing, the process of measuring capacitance and dissipation, helps you determine the condition of a system’s...

  • A primary current injection test set injects a powerful current on the primary side of protective relay equipment or current transformer to...

  • Switchgear, or relay testers, are ideal for testing Single, 3, 4 and 6 Phase protection relay systems. Commissioning tools compliant for IEC 61850...

  • In secondary current injection testing, a strong current is inserted directly into a trip relay to test a circuit breaker. Current injection is a...

  • Sweep frequency response analyzers, or SFRA, evaluate the mechanical integrity and electrical transfer function in power transformers. These...

  • A circuit breaker tester determines whether a circuit will trip in case of an emergency or random fluctuation in current. Transients, rogue bursts...

  • Thermal cameras are able to identify hot points, leakage, and other thermal issues by using real time video feeds, which are captured for later...

  • Transformer turns ratio (TTR) equipment has been specifically designed to conduct TTR testing. These tests are able to verify the operating...

  • VLF, or Very Low Frequency testers, are used to conduct VLF Withstand Tests. These tests are typically carried out on a frequency between 0.1 Hz...

  • Winding resistance is defined as the resistance of a length of copper wires from one end to the other. It is a measurement of DC voltage and...