Amplifier Research 100S1G6AB Microwave Amplifier, 1 - 6 GHz, 100W

Rent Amplifier Research 100S1G6AB Microwave Amplifier, 1 - 6 GHz, 100W
Enlarge Image
Request Quote Print Page
Datasheet
The model 100S1G6AB is a solid-state, Class AB design, self-contained, air-cooled, broadband amplifier designed for applications where instantaneous bandwidth, high gain and linearity are required. Housed in a stylish contemporary cabinet, the unit designed for benchtop use, but can be removed from the cabinet for immediate equipment rack mounting.

The Amplifier Research 100S1GAB, when used with a sweep generator, will provide a minimum of 100 watts of RF power. Included is a front panel gain control which permits the operator to conveniently set the desired output level. The 100S1GAB is protected from RF input overdrive by an RF input leveling circuit which controls the RF input level to the RF amplifier first stage when the RF input level is increased above 0 dBm. The RF amplifier stages are protected from over-temperature by removing the DC voltage to them if an over-temperature condition occurs due to cooling blockage or fan failure. There is a digital display on the front panel to indicate the operate status and fault conditions if an over-temperature or power supply fault has occurred. The unit can be returned to operate when the condition has been cleared. All amplifier control functions and status indications are available remotely in GPIB/IEEE-488 format, RS-232 hardwire and fiber optic, USB, and Ethernet. The bus interface connector is located on the back panel and positive control of local or remote operation is assured by a Local/Remote switch on the front panel of the amplifier.

The low level of spurious signals and linearity of the Model 100S1G6AB make it ideal for use as a driver amplifier in testing wireless and communication components and subsystems. It can be used as a test instrument covering multiple frequency bands and is suitable for a variety of communication technologies such as CDMA, W-CDMA, TDMA, GSM etc. It is also suitable for EMC Test applications where undistorted modulation envelopes are desired.

The export classifications for this equipment is 3A001. These commodities, technology or software are controlled for export in accordance with the U.S. Export Administration Regulations. Diversion contrary to U.S. law is prohibited.
 

Amplifier Research 100S1G6AB Specifications:

 
Rated Power Output: 100 watts minimum (1.0 - 6
GHz)
Input for Rated Output: 1.0 milliwatt maximum
Power Output @ 3dB Compression: Nominal: 100 watts
Minimum: 80 watts
Small Signal Gain Flatness: ±1.5 dB typical
±2.5 dB maximum
Frequency Response: 1.0 - 6 GHz instantaneously
Gain: 50 dB minimum

Model Configurations:
 
Model RF Input RF Output
100S1G6AB Type N female, front Type N female, front
100S1G6ABM1 Type N female, rear Type N female, rear
100S1G6ABM2 Same as 100S1G6AB; enclosure removed for rack mounting
100S1G6ABM3 Same as 100S1G6ABM1; enclosure removed for rack mounting
100S1G6ABM4 Type N female, front Type N female, rear