The ENI/E&I A500 RF Power Amplifier 300 kHz - 35 MHz, 500 Watts has been replaced by the RF Power Amplifiers.
View the RF Power Amplifiers
The ENI / E&I A500 Power Amplifier is primarily designed for use in HF transmitters, nuclear accelerators, NMR systems, plasma equipment and RFI / EMI applications. These extraordinarily compact and efficient RF sources will operate reliably under the most extreme environmental conditions without damage or failure.
Highly Linear Class A units will amplify AM, FM, SSB, Pulse and other complex modulations with minimum distortion. Unconditional stability and absolute protection against overdrive and overload makes them ideal for applications involving highly mismatched or non-linear loads such as gas plasmas. Their high gain and flat frequency response makes them compatible with all laboratory signal generators and synthesizers.
Front panel meters display RF output voltage as well as power output into 50 Ω. Integral regulated power supplies and cooling systems permit full power operation over a wide range of temperature and AC line conditions.
- All solid state
- Flat 0.3 to 35 MHz
- No bandswitching
- Works into any load impedance
- Easy Maintenance
||300 kHz to 35 MHz
|Maximum Class A Linear Power Output
|Maximum Pulse & CW Output
|Drive Source Requirements
||Any signal generator, function generator, or oscillator capable of 0dB (±3 dB) of output into 50 Ω
||208, 230, 245 VAC, tap selected; ±5% 50 Hz - 60 Hz at 20 A
|Front panel-mounted power output meter
||0 - 225 Volts, 0 - 900 Watts
||26.5" H x 17" W x 22.5" (67.3 x 43.2 x 57.1 cm)
||165 lbs (74.8 kg)